Homebrew masterone E question

[Sigh]

Hey guys. I just brewed some masterone E 200/ML. AND AFTER 24 hours it has turned a bit cloudy and has a small amount of sandy/powder in it. I mixed it with 2% BA 18% BB AND THE REST OIL. I cooked it on the stove for 8-10 minutes in the beaker with a small boil. Should I add more BB? 20-25 maybe? Think that will break it down properly. From what I've been reading. That seems to be the standard amount of BB. Any info would be great. Thanks

PS. THIS WAS MY FIRST TIME BREWING MAST. SO ITS A LEARNING CURVE.

- - - Updated - - -

Just to confirm. I did filter it with a standard size watmann filter.

 

[muskate]

I wouldn't add anymore BA or BB. Adding anymore is going to cause extreme PIP when you inject it.

Your home-brewed mast e is most likely fine to use. All the steroid didn't completely suspend in the oil carrier.

Boil some hot water with a kitchen kettle. Place the vial in a soup bowl and pour hot water until it comes 2/3 the way up the side of the vial. Let it sit there for 2-3 minutes and then shake the vial vigorously for 30 seconds. That should re-suspend the mast e in the oil carrier.

If that doesn't work, there are some impurities in the raw steroid powder you got from your China source.

 

[BodyEnergy]

You can put in few drops of EO warm the vial to 80 degreess than cool it down and repeat 1-2 times.
If you dont have EO warm the vial to 80degrees as well 1-2 times and see what happens.
It could be crashed or some moisture in it but sometime for personal use is ok.

- - - Updated - - -

Also i agree with muskate way

 

[Sigh]

Great thanks guys. I already tried reheating it. And Same thing happens. So maybe I'll try the EO thing. I could just warm it up before every injection. But it's hard with kids running around. Don't want them to see it.

 

[Masonic Bodybuilder]

Great thanks guys. I already tried reheating it. And Same thing happens. So maybe I'll try the EO thing. I could just warm it up before every injection. But it's hard with kids running around. Don't want them to see it.

Try the EO idea and see if that fixes it.

 

[LevButlerov]

After looking at all this trouble, I start wondering if it is even worth all the trouble homebrewing your gear. I understand that it is cheaper this way, but don't you run the same costs in the end of the day?

 

[Sigh]

Not a chance bro. The cost is t even close.

 

[BodyEnergy]

After looking at all this trouble, I start wondering if it is even worth all the trouble homebrewing your gear. I understand that it is cheaper this way, but don't you run the same costs in the end of the day?

Bro homebrewiing for me goes over the cost and if u do it carefully respecting every passages it is very hard to get your gear broken.
I never will go back

 

[Sigh]

The cost wasn't the only reason for me to start home brewing. This way, I know it is sanitized and properly done. Who knows if the person who was making your gear had an itch on his ass in the making process. Just a better sense of wellbeing.