Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
Research Chemical SciencesUGFREAKeudomestic
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsResearch Chemical SciencesUGFREAKeudomestic

Rubber stopper breaking.... need tips

UNIT

Member
Registered
im on my second vial of test and it looks like the rubber stopper keeps getting into the vial

im using a 20g needle for drawing

i try to rotate where i insert the needle but still pieces of the stopper are still going into the vial

i also notice that some oil leaks from the stopper after drawing not sure if this is normal?

what can i do to stop this from happening? is a 20g needle too big for drawing?
 
i draw with an 18G and i don't have that issue. what brand you using?
 
im on my second vial of test and it looks like the rubber stopper keeps getting into the vial

im using a 20g needle for drawing

i try to rotate where i insert the needle but still pieces of the stopper are still going into the vial

i also notice that some oil leaks from the stopper after drawing not sure if this is normal?

what can i do to stop this from happening? is a 20g needle too big for drawing?

Depends on the brand, if you notice the rubber stopper is breaking that means you should preload a few syringers and keep them in a clean place, think of it as the sustanon preloads back in the day.

20G is not too big, I've drawn out with 18G. But with multi-dose 10ml vials, rubber stoppers are hit and miss, sometimes the suppliers provide the sources bad ones.
 
I use 18G max, 20g is to large and some manufacturers are using cheap supplies and in this case - rubber
 
You should contact the supplier asking for another one.
 
If you get some stopper in the vial it isn't really a big deal. You don't want it to keep happening but a little bit isn't going to get into the syringe.

maybe to you its not a big deal but i dont wanna be injecting that shit into my body... and it did get into the syringe i had to toss it
 
im on my second vial of test and it looks like the rubber stopper keeps getting into the vial

im using a 20g needle for drawing

i try to rotate where i insert the needle but still pieces of the stopper are still going into the vial

i also notice that some oil leaks from the stopper after drawing not sure if this is normal?

what can i do to stop this from happening? is a 20g needle too big for drawing?



The rubber stopper should not be doing that man. Even with a large needle that shouldn’t happen. You might have some trash from some bad UGL that’s using old rubber they got at a discount or something that’s not suitable for the use.
 
Back
Top Bottom