Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply US-PHARMACIES
UGL OZ UGFREAK OxygenPharm
napsgeargenezapharmateuticals domestic-supplyUS-PHARMACIESUGL OZUGFREAKOxygenPharm

Question about tren ace/hex

MattGShock

New member
I am looking at running a blend of 100 tren ace/100 t prop/100 mast eod. Is there any positive benefit to running hex in the blend instead of ace? Also what am I going to need to run with it? Caradrine, caber, and liver support? Anything else? I'll lay out a planned cycle to get some input I just have to figure out what I'm going to actually do.


Sent from my iPhone using Tapatalk
 
Instead of the ace?? No not at all hex halflife is longer than E.. Stick with ace... Caber, Aromasin, N2Guard for starters
 
Thanks snow. So I'm going to run with the ace. I'll also pick up caradrine, aromasin, and caber. Any good sources for all 3 so I can get in one swoop?


Sent from my iPhone using Tapatalk
 
Looks like I'll get aromasin and dostinex from ag-guys and the caradrine from my usual source. Mike would you mind laying out a cycle for me?


Sent from my iPhone using Tapatalk
 
From what I read, its better than tren e, based on what I read on the profile for Evo but I wouldn't know


Sent from my iPhone using Tapatalk
 
You sure it's just tren hex and not tren ace / hex ? Because that's a little different.. I know Robo sells his hex is Parabolan but I'm not sure if it's just hex or multiple esters
 
Yes sir. Just straight parabolan on the list. But anyhow I'm goin with ace! I'm just excited to finally have a reliable domestic source lol


Sent from my iPhone using Tapatalk
 
Well you said you are running a blend aren't you ? Therefore you have no control over individual dosages, only total
 
Well I could get a custom blend or just pull from separate vials if need be. Why do you ask? @mikesnow


Sent from my iPhone using Tapatalk
 
Well didn't you ask me to lay a cycle out for you ? It makes a huge difference if it's a tri blend or 3 separate vials dude
 
The pre made blend would be cheapest for me. And yes I did. If you think I should use separate vials I could opt for that instead.


Sent from my iPhone using Tapatalk
 
Well I'm assuming it's a cut.. Have you ever used tren before? Do you prefer test higher or lower to tren? What's your BF % ?
 
I've never used tren so I have nothing to base it off of. But I am at about 12-15% I plan on cutting to 7-10% before my first pin I've still got plenty of time


Sent from my iPhone using Tapatalk
 
Back
Top Bottom