Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply US-PHARMACIES
UGL OZ UGFREAK OxygenPharm
napsgeargenezapharmateuticals domestic-supplyUS-PHARMACIESUGL OZUGFREAKOxygenPharm

sustanon question

chip108

New member
Registered
I am sure that this topic has already been discussed here but I have to ask.
Compare to other steroids like deca, testosterone, sustanon post injection pain is through the roof?
My question is what is it with Sustanon that causes so much pain?
I usually inject in my outer thigh and the next day I can barely walk. My thigh swells up, hurts like hell, and gets very warm.
I have tried placing an ice pack, and or heating pad to see if the pain subsides; only a little. It usually takes a couple of days
where my thigh starts to feel normal again. It almost make me hate Sustanon.

Whom else here has the same type of problem.

-CL
 
I've done quite a few companies Sustanon.
And for some Damn Reason, I've found that the UGL's don't have any PIP.
Whereas the Pharma-Grade Sustanon & Omnadren are the Worse.................................................. JP
P.S.
A few years back I did some Jelfa~Omnadren.
That Shit had me Crippled for days.
 
I've run GP's Sustanon 270 a few times, but never have I experienced any of the symptoms described by chip108. In fact, I've never had any problems with GP's Sustanon.
 
Pharma grade does that champion. Its the way its put together. I usually would administer in the glutes to prevent discomfort in the leg. Looks really unusual when you begin limping from pain. I would rotate on glutes to prevent severe discomfort on other parts of the body.
 
Some compounds just cause more PIP then other compounds. There is no real rhyme or reason, it is just the nature of the steroid. Test prop is a great example. Test prop will cause more PIP then test e or test cyp in 99.99% of users. It is just how it is.

Here are some tips for reducing PIP:

1. Heat up the oil prior to injecting. Run the vial under hot water for 1-2 minutes. Heating up the oil will bring it closer to body temperature and make the oil disperse from the muscle into the blood stream much easier.

2. Gently massage the injection site for 1-2 minutes after the injection. It'll help disperse the oil into the blood stream.

3. I am a big advocate of training the muscle you injected into that day. It'll help disperse the oil from the muscle into the blood stream. In other words, try to time your glute injection on the day you train legs/glutes.
 
I would use glutes personally for such injections. I recall once I did a quad injection and got the worst PIP possible - took 15 minutes to get out of bed for a few days. Not the best feeling in the world.

Also, it highly depends on the lab that you are using. It might even be a batch where they put too much BA
 
Must be the BA% that your lab is using as Jay mentioned. I would ask your lab what % they use. As a rule of thumb should be about .02%. I know some labs will use .05% and that is where you will get that nasty PIP. Other option would be look for another sustanon source.
 
BA is usually at a standard .2% Only reason for higher BA is for higher concentrations.
Ive found shorter esters causing pain where as longer ones don't. BA is a factor though
 
Interestingly, I would rather say that it mostly depends on the brand and quality of the product, rather than on the class of compound. Yes, with certain compounds (propionate or suspensions) the PIP is more frequent than with others, but as a general rule, the quality of the product will determine how much PIP there will be. For instance, I am using the sustanon from Berd Pharmaceuticals, and did not have even the slightest PIP so far.
 
Back
Top Bottom