Heating test

[Texan45]

Does heating a test e vial ruin the fear or lower the potency of the testosterone at all?
What I did was put water in a Pyrex cup and popped it in the microwave for 2mins
Then took it out and placed my test vial in the water for about 45 seconds twirled it around and then drew it out.


Second question is how can you tell if your fear crashed?

 

[muskate]

Heating testosterone does not lower the potency of it. The melting point and denaturation point of cholesterol based hormones like steroids is over 450 C. A temperature so high that you couldn't reach it with your regular kitchen equipment.

Peptide hormones like GH and insulin become denatured VERY easily because they dont have a cholesterol backbone but it would be pretty much impossible for you to denature any steroid in your home kitchen.

You can heat up any steroid prior to your injection exactly like you did and it's something I actually recommend. Heating up the gear before your injection will make the injection go faster and reduce PIP.

When your gear is crashed, that means the UG lab put more raw hormone then will suspend in the oil. As a result, the gear separates. It's not a big deal. You just need to heat up the vial to re-suspend the hormone into the oil. Crashed gear doesnt mean your gear is bunk or bad or anything like that. It actually means your gear is MORE potent then it should be.

 

[Texan45]

Awesome thanks bro that really answers my question, much appreciated man!

 

[stevesmi]

i once heated my vial in a toaster oven. not a good idea. the glass melted and it was a mess!

the best way is using a toaster and monitoring it very closely

 

[jp4355]

When I use EQ, I always put it into some Water that I Microwave 1st.

This way it's easier to Draw-up with my 25 gauge.

You can Heat and Reheat your Gear without Fear of it Losing Potency..................................... JP
P.S.
Sometimes when you get Gear through the Mail in Winter, it's Crashed, especially if it's Extremely Cold.
You'll see the Hormone makes Crystals in the Carrier Oil, just pop it into some Hot Water and it'll Reconstitute.

 

[goldprospecto]

Agreed.. Hot water is the way to go. Definitely makes the draw and stick easier.

 

[Masonic Bodybuilder]

I just put my vials in a cup of hot water and have a shower while it sits there. I just use the water out of the tap as hot as it goes. I don't heat it in a microwave or anything.

 

[Fit_PharmD]

I find it is much easier to draw and inj after beating the vial. I use a lighter, which may sound archaic but as long as the flame does not touch the vial you are fine. I just wave the vial over the flame for 10-15 sec and that's all it takes to warm it enough to draw it easier. Obv you have to give it a min before inj bc the hot oil will burn as it goes in and cause some tissue damage.

 

[Jay Scott]

i once heated my vial in a toaster oven. not a good idea. the glass melted and it was a mess!

the best way is using a toaster and monitoring it very closely

Dude, how did you come up with that?

The vial couldve exploded as well.

 

[offtap]

i once heated my vial in a toaster oven. not a good idea. the glass melted and it was a mess!

the best way is using a toaster and monitoring it very closely

I'm not judging much, but that is silly...

Sent from my Nexus 6 using Tapatalk