Please Scroll Down to See Forums Below 
So what's up Bros I had a question if you were running a cycle at 400 mg of test for week split into two injections would it be better to use test 400mg/ml at a half a ml twice a week or test 200mg/ml at 1 ml twice a week now before everybody says you're an idiot I know milligram wise no matter what it's the same dosage but I was wondering if it would be less pinning and pain in the injection site with the 400 mg at a half a milliliter because of less oil at the injection site
hey man i moved your thread over to the main AAS section instead of the source section so you will get more responses
i have never pinned more than 250mg/ml test per CC and i am a person who has PIP sensitivity so i am always going to rather go that route. 400mg/ml can cause more post injection pain, but sources are getting better and better at coming with smoother products even at higher #'s
i have never pinned more than 250mg/ml test per CC and i am a person who has PIP sensitivity so i am always going to rather go that route. 400mg/ml can cause more post injection pain, but sources are getting better and better at coming with smoother products even at higher #'s
I'm not injecting at the same site you must have misunderstood what I said
Most UGL's are improperly dosed. It has been my experience to go with a lower mg per ml. It's easier to dial stuff in that way. I've had test that 3 shots in my nipples hurt and a constant erection.
I've had other stuff that I have run that I had to bang 2x what I normally would.
Just saying
I've had other stuff that I have run that I had to bang 2x what I normally would.
Just saying
@fullyrebilt well I would do test in 3 injections or 2 minimum, i dont like weekly injections
but again , we just talked in your other thread as a community and you promised you would put up a log?
and you got instructions how here
https://www.evolutionary.org/forums/threads/first-cycle.97080/post-1451399
so why havent you put up a log journal for us? we are waiting
LOG APPROVED - PLEASE POST A LOG
This thread/post was reviewed by our Medical Review board.
This thread/post/message was also fact checked by Steven Darwin, MD and our medical review board.
Full editorial process was followed, and please read our medical disclaimer, check our editorial process.
This thread/post was reviewed by our Medical Review board.
This thread/post/message was also fact checked by Steven Darwin, MD and our medical review board.
Full editorial process was followed, and please read our medical disclaimer, check our editorial process.
LOG your experience using testosterone 400
this way you can see how you like it and we can give you advice from there
this way you can see how you like it and we can give you advice from there
at the end of the day you're going to like what you're going to like
the nice thing is domestic Supply has all your options covered when it comes to testosterone and everything else
the nice thing is domestic Supply has all your options covered when it comes to testosterone and everything else
bro you might like sustanon. it comes usually 250 or 350mgs
go check it out from napsgear
go check it out from napsgear
Because I'm not doing a cycle right now I won't be doing a cycle for about 3 months I'm just gathering information
You ended the question with 'cos oil at the injection site'.
1. It's either the same site (you say no)
2. Volume of oil per jab (2ml is fine esp if injected deep enough)
3. An allergic reaction to the carrier fluid (Stevesmi is correct)
4. Occasionally (rare now) too high of an alcohol percentage.
But like I said the usual issue is too high mg per ml. As I said on a podcast (repeating some the late Rich Piana also stated) why do labs do it (cos customers ask for it not cos it's better) when the original phara company did not. Said pharma company could charge more so it's not the money and deffo has the cash for development.
There's zero to the idea of better gains etc. The main reason for using a high mg per ml is less pinning
@fullyrebilt Logs start BEFORE a cycle not when a cycle starts, takes MONTHS to dial in diet and training before you inject, you should NOT be using steroids if you can't have the dedication to keep a log on the forums.
Looks like the guys got ya covered
test 400 is not ideal.. the higher the concentration, the far more the PIP... its just so easy and smooth to use a lower concentration... even injecting a lower amount, it will still carry the PIP with it..
Similar threads
